Homebrew 2m 144 MHz vertical 1/2 wave Coaxial Dipole antenna for QTH, SOTA & portable field operations/WICEN exercises.
- 7m length of 50 ohm RG58AU/CU Mil Spec coax
- 1 * 50 ohm BNC connector
- 2 * 1 metre lengths of 27 mm water pipe (Bunnings)
- 1 * End Cap
- 2 * T-piece connectors
- 1 * 300 mm Ground Spike (Bunnings)
- 25 mm dowel offcut
- 1 * Guying Ring
Photos and diagrams: © Copyright 2018 Andrew VK1AD
RigExpert 600 MHz Antenna Analyser VSWR results
Return Loss measurement
Start by removing the braid from the top section exposing the inner conductor. Leave the dielectric insulator intact.
Choke hole spacing = 45 mm (9T x 5 mm)
From the top of the tube measure 918 mm and mark the top hole position. Drill a 2 mm pilot hole followed with a 6 mm drill bit (hole size and spacing will vary with coax diameter). Using a round file, elongate the hole in the direction of the winding. Center-to-center hole space = 45 mm.
On a 27 mm former the choke section is 910 mm. The length of the choke section will vary with changes in pipe and coax diameter. Do not cut the coax.
Starting with the radiator. Feed the radiator section through the top hole towards the top of the antenna, stop feeding once your 450 mm mark aligns with the top winding hole. Look closely at the photo, you can see my pencil mark where the coax enters the tube.
Next wind 9 tight turns around the tube then feed the remaining 5 metres of coax through the bottom winding hole. Be patient this step will take a few minutes.
Holding the pipe in one hand use the other hand to ‘twist’ the cable tight. There should be no slack in the choke.
I used a short section of dowel to form a center guide for the inner conductor. This helps to keep the radiator section centered inside the tube. Use a short section of fishing line to pull the top section tight. Secure the guide and inner conductor assembly with hot glue. Finally add an End Cap to weather proof the top.
Weather proof End Cap
50 ohm BNC connector assembly, I prefer the solder type.
Easy to deploy lightweight portable antenna.
Ground spike support – Top cylinder section of the spike fits neatly into the plastic T-piece connector (see next photo)
Portable 2m (144.2 MHz) 1/2 wave Coaxial Dipole mounted on a 1 metre extension. To elevate the antenna add additional 1 metre pipe extensions as required. You may need a guying ring a guy ropes for two or more extensions. Place the guying ring over the top T-piece below the 9T choke.
Not shown in the photo, I plan water proof the choke winding with a length of heat-shrink tube.
27mm OD water pipe from a local hardware store
Enjoy constructing your own version of the 2m coaxial dipole antenna known elsewhere in the radio amateur community, for obvious reasons, as a Flower Pot Antenna. Place the bottom 1 metre pipe extension in a flower pot.
First published: 10 February 2018
Last Update: 12 February 2018